Make Your Own Viking Knit Tool

To start Viking Knit the conventional way, one generally fashions a

Flower

Five or Six-leafed petal out of wire

Flower2

secures it to the top of a dowel, and then starts the weave from there.   I decided to try making a tool to make the process a little easier.  I am posting this because some people might find it helpful.

Screws

I took a wooden dowel about 3/4 inch thick and drew a six slice pie on the top with a Sharpie marker.  I continued those lines down the sides of the dowel mandrel using a ruler to draw them straight.  These are guide lines for the Viking Knit.

 

TopView

I used a rotary tool like a Dremel to drill pilot holes for small screws.  I screwed the screws into the mandrel by hand.  You have to go slowly because it’s easy to split the wood.  Don’t use a hammer.

Starting Loops

 

This picture shows how I loop the beginning wire off of which I will work the Viking Knit.  I have used a bit of tape to secure it.  You could also hold it in place with a band of wire under the screws.  Since this part will be cut off, it doesn’t matter what it looks like so long as you are comfortable with it and it works.

 

 

First Row

 

This  is the start of the weave.

 

8Rows

The lines help you to keep your rows straight.

IMG_8009

 

This is the single weave knit that I’ve removed from the dowel after cutting off the starting loops.  (This is 24 gauge copper wire)  I have another dowel the same size as the starter tool I made and I could slip the open weave onto that and keep weaving for a longer chain.  That would help me to keep a uniform shape.  There are those who would be able to do this without the dowel, but I am not one of them!

Length before Reduction

 

I made about 10 inches of weave and pulled it through the drawplate until it was about  18 inches long

Pliers

 

I recommend using wire drawing pliers because it makes the job so much easier.  They don’t have to be expensive.  

You could put end caps and  a clasp Viking Knit at this point.  Here’s a video that shows how to do that.

 

But you don’t have to be limited  to end caps and clasps.  Next week I will post on a new idea for designing and finishing single knit Viking Weave that I hope gets your creative juices flowing.

One response to “Make Your Own Viking Knit Tool

  1. Pingback: A New Twist on Viking Knit! | Ornamento·

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s